Module Configuration

Modules are included in the firmware and allow users to extend the functionality of their mesh or device.

Name	Description
Ambient Lighting	Adjust the brightness of NCP5623 I2C RGB LEDs
Audio	Enable Support for Codec2 Voice Comms on certain devices.
Canned Message	Set a number of predefined messages to send out directly from the device with the use of an input device like a rotary encoder.
Detection Sensor	Configure a GPIO pin to be monitored for specified high/low status and send text alerts.
External Notification	Incoming messages are able to alert you using circuits you attach to the device (LEDs, Buzzers, etc).
MQTT	Forward packets along to an MQTT server. This allows users on the local mesh to communicate with users on another mesh over the internet.
Neighbor Info	Send info on 0-hop neighbors to the mesh.
Paxcounter	Count the number of BLE and Wifi devices passing by a node.
Range Test	Send messages with GPS location at an interval to test the distance your devices can communicate. Requires (at least) one device set up as a sender and one as a receiver. The receiver(s) will log all incoming messages to a CSV.
Remote Hardware	Set and read a GPIO status remotely over the mesh.
Serial Module	Send messages across the mesh by sending strings over a serial port.
Store & Forward	Stores messages on a device for delivery after disconnected clients rejoin the mesh.
Telemetry	Attach sensors to the device and transmit readings on a regular interval to the mesh.
Traceroute	Track which nodes are used to hop a message to a certain destination.