Skip to main content

Environmental Measurement Plugin Settings

Overview#

caution

This is a work in progress and is not yet available.

The Environmental Measurement Plugin will allow you to connect climate sensors to report local conditions to your mesh.

Settings#

SettingAcceptable ValuesDefault
environmental_measurement_plugin_measurement_enabledtrue, falsefalse
environmental_measurement_plugin_display_farenheittrue, falsefalse
environmental_measurement_plugin_read_error_count_thresholdinteger0
environmental_measurement_plugin_recovery_intervalinteger (seconds)0
environmental_measurement_plugin_screen_enabledtrue, false0
environmental_measurement_plugin_sensor_pininteger0
environmental_measurement_plugin_sensor_typeDHT110
environmental_measurement_plugin_update_intervalinteger (seconds)0

environmental_measurement_plugin_measurement_enabled#

Enables the plugin.

environmental_measurement_plugin_display_farenheit#

The sensor is always read in Celsius, but the user can opt to view the temperature display in Farenheit using this setting.

environmental_measurement_plugin_read_error_count_threshold#

Sometimes sensor reads can fail. If this happens, we will retry a configurable number of attempts Each attempt will be delayed by the minimum required refresh rate for that sensor

environmental_measurement_plugin_recovery_interval#

Sometimes we can end up with more than read_error_count_threshold failures. In this case, we will stop trying to read from the sensor for a while. Wait this long until trying to read from the sensor again

environmental_measurement_plugin_screen_enabled#

Enable/Disable the environmental measurement plugin on-device display.

environmental_measurement_plugin_sensor_pin#

Specify the preferred GPIO Pin for sensor readings.

environmental_measurement_plugin_sensor_type#

Specify the sensor type

environmental_measurement_plugin_update_interval#

Interval in seconds of how often we should try to send our measurements to the mesh.

Details#

Examples#

TODO